PFEP – ۲۱۵۰

DATA SHEET

Epoxy flooring

Description:

It’s based on epoxy resin and polyamide hardener. It has very high permeability and permeates deep into the concrete, due to its low viscosity. It has high adhesion to concrete surface and prevent exiting dust of concrete pores. Very good water and chemical resistance. The surface of this coating is washable and resistant against chemicals and detergents.

Advantages:

  • Very low viscosity
  • Excellent permeation capability in concrete pores
  • Prevent exiting dust of concrete pores and environmental pollution Covering surface imperfections of concrete
  • Increase abrasion resistance
  • Protects concrete against chemicals, such as: acids, alkalis, gasoline, petroleum, petrol…

Main uses :

  • Anti-Dust floorings on the concrete/brick/cement…surfaces where it is not expose to direct sunlight

Characteristics:

Color  Gray, dark blue and any color ordered
Gloss Glossy
Components 2
Mixing Ratio by weight A/B=2/1
Mixing Ratio by volume A/B=2/1
Pot life 4.5 hours @ 5°c

3 hours @ 25°c

2.5 hours @ 35°c

% solid volume (A+B) 50%
Density (A+B) 1.05±۰.۰۵ gr/cm3
D.F.T 200 Micron
Consumption 400 g/ m2

For 200 Micron

Curing method Solvent vaporization and Chemical reaction
Thinner T-950 Epoxy thinner
Shelf life 12 months

In closed containers , not exposed to direct sun light in 5-30ºc

Packaging A: 8 Kg

B: 4 Kg

Processing properties

Pot life 45 min
Dust free time 4 hours
Post curing time 6 hours
Full curing time 7 days
Over coating interval 3-12 hours

Application Guide Direction:

Surface preparation:

The surface should be free of any contamination and loos area, because this material decrease adhesion between coating and surface. If the surface need to repair do it before flooring. In case of high surface absorption, apply PFEP-2168 POLYGUM concrete Epoxy primer. The coating can be applied in multilayers if necessary.

Ambient condition:

Ambient temperature while application should be between 5- 50ºc. The ambient temperature should be 3˚C more than dew point.

Application procedure:

After surface preparation, Mix 2components (according instruction of packaging) with agitator until a homogenous liquid achieves. Pour the mined compound on the floor and spread it with trowel or roller. In closed area air conditioning during operation time is necessary.

After application clean the tools with Epoxy thinner T-950.

Please note PFEP –۲۱۵۰ is not suitable for wet and oil contaminated concrete surfaces.

share :
Facebook
LinkedIn
Telegram
WhatsApp